Vehicle Specific

Information Center






  Home > Supra - MKIII > Assemblies >

7M-GTE Knock Sensor Re-Wire Kit
7M-GTE Knock Sensor Re-Wire Kit


 
Alternative Views:


Our Price: $55.00

Product Code: SUP-003

Knock Connectors

Install connectors*:

Turbo or NA



Qty:  
Description
 

Do you have damaged knock sensor wiring? Replace both front and rear knock sensor wires in your 7M-GTE harness. The two wire sets are marked FRNT (front) and REAR. This kit does NOT include new knock sensor connectors, you must re-use your old connector housings. The harness has new pins and seals that will work in your old housing, gain peace of mind that your harness has new parts in it!

This is high quality air-craft grade shielded wire, buy in confidence!

The grounds for the shielding has been stubbed out on the ECU side so you can connect it to the factory shielded ground.

The ECU side has been stubbed out so it can be installed on both Pre and Post-89 engine harnesses.

Note: Special tooling (crimper) is needed to connect the ground and ecu stub outs, improper crimps can cause wire pull out or reduced capacity. Profession installation is recommended.

Share your knowledge of this product. Be the first to write a review »